Armor All® Ultra Shine Headlight Restoration Wipes will give your car headlights a stunning sheen in two steps. No tools or sandpaper needed.

Step 1: Oxidation Removal

AVOID CONTACT WITH PAINTED SURFACES.

Use painter’s tape to protect painted surfaces surrounding headlight.

• Ensure headlight is clean and dry.
• Open one Cleaning/Oxidation Removal pouch and remove wipe. Keep wipe folded to reduce evaporation.
• Scrub headlight with firm, even pressure in a horizontal back-and-forth motion. You will notice the oxidation residue beginning to be removed.
• Turn the wipe to a clean side, keeping the wipe folded.
• Continue to wipe, turning wipe to clean section as needed until no residue is visible on wipe. Discard wipe.
• Open a second Cleaning/Oxidation Removal pouch and continue wiping back and forth with firm pressure for at least 2 minutes.
• Note: Though your headlight may appear clear, additional deep cleaning is necessary to ensure all oxidation is removed.
• Repeat the above steps on other headlight.

Step 2: UV Sealant Protection

• Ensure surface is dry before applying sealant. For best results, first wipe surface with a clean, lint-free towel.
• Open UV Sealant Protection pouch and pull out wipe.
• Apply to the headlight surface by wiping in one direction, similar to applying a coat of paint. One wipe will coat two headlights, but use additional sealant wipe if needed. Avoid contact with painted surfaces.
• Let surface dry completely. Surface will be dry to touch in about 3 hours. Do not touch surface and avoid contact with water until dry. If spotting or streaking occurs from water contact before fully dry, repeat Step 1 and Step 2 with fresh wipes.

Note: Drying time after Step 2 is dependent upon weather conditions. Drying may take longer in lower temperatures or higher humidity.